You can rinse the water base, and perhaps the hose too. Wood, coatings and multi-part bowls need different care. A few suitable tools and a clear sequence make the job easier. Treat each component according to its material.
Prepare and take apart
Let the bowl and metal parts cool completely. Empty the water base and undo only connections intended for dismantling. Put small seals and valve parts in a dish so they cannot disappear down the drain. Have a soft cloth and suitable soft brushes ready; follow the manufacturer’s instructions for cleaners and water temperature.
Clean the base and inner tubes
Rinse parts approved for washing and loosen residue with a suitable brush, without forcing it through narrow openings. Avoid sudden temperature changes in glass: pouring hot water into a cold base is no shortcut. Do not use scouring pads or harsh household cleaners. Any cleaner used on coated metal or acrylic must be suitable for that material. Rinse it away completely afterwards.
Care for wood and leather surfaces separately from the inner tube. WOOKAH, for example, specifies gently rinsing the inner tube while wiping the outer wood with a damp cloth. Soaking the whole component would be the wrong approach.
Hose, bowl and drying
Rinse a hose only if that model is explicitly washable. Remove detachable mouthpieces and connectors as instructed and clean them separately. Washable does not automatically mean dishwasher-safe. Check each insert and attachment of a multi-part bowl: with the Quasar RAAS 2, for example, the glass insert and silicone connector can be washed with water, but the lid and heating unit cannot.
Let every cleaned part dry completely, including the inside of the hose, before reassembly or storage. Check seals and connections for damage. Replace cracked or damaged components with compatible parts; harder scrubbing will not repair them.
